3 Tab Shingles:
The 3 tab shingle has a 20 to 25 Year Warranty. These Roofing Shingles can be found on the majority of homes in almost any neighborhood. Roofing Prices range from $75.00 to $85.00 per square. (1 square of roofing covers 100sq feet or a 10ft by 10ft area)

The Dimensional Shingle:
Dimensional shingles Range from a 30 year warranty to a Lifetime prorated warranty. Most manufactures have upgraded all dimensional 30 year shingles to lifetime warranties nothing real different in the shingles similar to extendended warranties on cars you pay more for the warranty in the price of the product.$105.00 - $120.00 per square This shingle also requires a special Ridge cap and starter strip.

Ice and Water Shield:
Ice and water shield Is a rolled product that is applied to the eaves of the house. Most city codes require this underlayment to extend 2 feet inside the exterior wall. It is used for protection against Ice back up. Prices for this material start off at $55.00 per 1 1/2 square roll. The roll measures 50 ft long by 3 ft wide. It is also recommended for use in valley areas and any penetrations through the roof.

15 and 30 pound felt or tar paper:
Felt Paper / Tarpaper Underlayment is a rolled product that is applied to the roof decking after the Ice and Water Shield has been laid. It's purpose is to absorb condensation that forms under the shingles. 15 pound Shinglemate felt is recommended on most roofs because it is fiberglass reinforced and will lay a lot flatter than an organic felt. Price for a 4 sq roll of Shinglemate is $44.00 - price for organic felt 4 sq roll 15 pound is $24.00. a 2sq roll of 30 pound (mainly used for cedar shakes or tile) is $24.00 per roll.

Turtle Vents:
Turtle vents or box vents are used for static venting of attic spaces. Prices $10-$13.00 a piece

Ridge Vent
Material price starts at $5.00 per foot  (Ridge Vent is used in place of regular Turtle vents.) Ridge vent is installed at the peak of the house where you would cut a 1 1/2 - 2 inch strip of wood across both sides of the peak than cover with the ridge vent. It comes in either a roll of plastic mesh which would then be covered by the ridge. or comes in 4 ft sections of plastic which also would be covered by ridge

Turbines Whirly Birds:
$60.00 a piece (Turbines or whirly birds are vents that spins an is made to suck air out of your attic)

Broan Vents:
Small $24.00 Large $36.00. Broan Vents are used to vent interior  bathrooms or range tops. (Small ones are for bathroom fans -- large ones are for range top fans.) There is a flapper inside this vent that opens when the fan is turned on and shuts when fan is turned off.

Plumbing stacks:
$22.00 for a led top shallow pitch and $29.00 for a led top high pitch. This flashing covers the plumbing pipes that are used to vent sewer gasses through your roof.

Valley Metal:
$24.00 for a 18 inch wide - $26.00 for a 24 inch wide w style. This is metal flashing that is used where 2 slopes of a roof come together.

Drip Edge:
$5.50 per 10 ft piece. Drip edge is used on the edge of the roof to keep water away from your fascia board. It extends under your shingles 3 inches than wraps down your fascia board 1 1/2 inches)

Wall Tins:
$.50 a piece  A wall tin is a 3x5 inch piece of metal bent in the middle at 90 degree angle and is used to flash areas of the roof that meet a wall or chimney. They are installed one at a time alternating shingle than tin than shingle.

Counter Flashing:
$22.00 per 10 ft piece.  Counter flashing is used to flash over the top of an exposed wall tin in areas where you would not be able to get a tin underneath the siding. like a stucco wall or brick chimney. The installation of this flashing requires a groove to be cut into the wall about a 1/4 inch deep and 1/8 inch wide (Also called reglet flashing.)

Nails:
1 inch nails are required for a 3 tab shingles 1 1/4 inch nails are required for a dimensional shingle. $39.00 per box for 1 inch. $40.00 per box for 1 1/4 inch. Typically 1 box is enough to lay 16 -18 square of shingles. 2 1/2 - 3 inch nails are required for installation of ridge vent $1.00 per pound.

Hammer Tack Staples:
$7.00 per box - Hammer tack staples are used to apply Ice and water shield and felt paper only.

Silicone:
$5.50 per tube for the good stuff Geocell is a good brand. (This should be used to divert water and not for filling holes in shingles. Uses Include exposed nails, seams in flashings, sealing shingles to metal etc...

*These prices are general prices and may be different depending on where you shop or the brand you choose *

For more Information visit ABC Supply (Click logo to enter site) or call 612-378-1820 Tell them Mike from Royalty Remodelers sent you. Or Try GAF For More Detailed Info.